Popular Articles
"DR Signal Off" alarm (often alarm 086 on a Fanuc)
This alarm occurs when the CNC checks the data ready handshake line (sometimes called DR or DTR) and finds that the device is not ready. There are a few possibilities for this problem depending on how your cables are wired. Verify that your port is ...
Mazak M32 configuration document
CNC Configuration Sheet Mazak M32 CNC Parameters: G1 = 2 (CMT 4800 baud) G19 - 2 (EIA 4800 baud) G20 - 3 (2 stop bits) G21 - 0 (even parity) G22 - 0 (Disable parity check) G23 - 3 (8 data bits) G27 - 0 (CR/LF) G29 - 3 (XON/XOFF) G30 - 1 (No DC Code ...
Fanuc 10T configuration document
CNC Configuration Sheet 10T CNC Parameters: Setting screen: Punch code- 1=ISO TV CHECK=0 OFF Under Service page: 0000 = xxx01000 (ISO) 0020 = 2 (Input device Foreground) 0021 = 2 (Output device Foreground) 0022 = 2 (Input device Background) 0023 = ...
Fanuc Part Count
Standard Machines (not looping the program) Fanuc machines will either part count on M30/M02 or a custom M code specified. To enable the machine to count on and M30/M02 parameter 6700#0(PCM) must be 0. If this parameter is set to 1, then it will ...
Haas Configuration Document
DC Systems | Haas Confguration Settings CNC Configuration Sheet CNC Parameters: Newer Haas: Press SETNG to bring up the machine settings. Press right arrow until you get to I/O tab. Press WRITE/ENTER button (lower right corner of panel). Use left ...