Changing CNC Parameters:
You will need to verify all parameters listed below that correspond to
your CNC control. These parameters may
not match your particular machine’s control.
Document (Phone camera) original settings before making modifications!
Place the NC into MDI modePress the SETTING function key until the "SETTING (HANDY)" page is displayed.
Cursor down to I/O Channel.
System (Param) screen:
Press > Screen button until Embedded appears.
Common. Enter the IP address for
machine, Subnet Mask, and Router IP if necessary.
FTP Transfer. Enter Host Name IP Address of PC/Server running the FactoryWiz Server software. (This must be a static IP Address!).
Folder path: (leave this field blank)
Restart to enable settings.
Select - Connect1
FactoryWiz DNC Settings:
1.01- Port Type: FTP_Server
1.03- IP Address of Fanuc control
(This must be a static
1.21- End of block (EOB): LF
2.11- Leader: %<10>
2.12- Trailer: %
2.23- Skip lines that contain: %
3.01- Use CNC defined filename
only True/False - If True, it will save program same as program stored in CNC.
- If False, it will use 3.11/3.12
3.11- Program identifier 1: O
3.12- Program Identifier 2: :
3.21- Receive timeout: 3
3.31- Ignore data before first
3.32- Ignore data after last
4.02- Request for file command:
4.03- Request for file command (drip
4:11- Request to save command:
After adding a new FTP machine, you will need to Restart
the FactoryWiz DNC Server Application/Service.
If you have
communications issue, make sure Firewall is turned off!!!!
output a program, set the CNC to "EDIT" mode.
Press the PROG key on
the control panel.
Display the program you wish to send on the screen by keying
in the program number then pressing the down-arrow button.
Press the Operate
Use the right screen keys (in softkey row under LCD screen)
until F Output appears.
Press F OUTPUT, Type in the program name, then press F
Queue file to be sent at FactoryWiz Clint
workstation first, then at machine control:
the CNC to "EDIT" mode.
Press the PROG key on the control panel.
Press the Operate (OPRT) softkey.
Use the right screen keys (in softkey row
under LCD screen) until F INPUT appears.
Press F INPUT, key in filename you
would like, (a Queued file will ignore what is typed in, so you can call it
anything, such as 0001.